Weider WESY19511 User Manual download pdf (Page 9)

11. During steps 11 through 24, refer to the CABLE

DIAGRAM on page 20 of this manual to verify

proper cable routing. Before beginning this sec-

tion, identify the Long Cable (23) and the Short

Cable (58) by comparing the lengths of the

cables.

IMPORTANT: While assembling the cables, do

not overtighten the bolts and nuts securing

the pulleys. The pulleys must be able to turn

freely.

12. Locate the Long Cable (23). Route the Long

Cable around the indicated 90mm Pulley (15)

attached to the Top Frame (55). Be sure that the

Cable is between the Pulley and the hook and

that the end of the Cable with the ball is on

the indicated side of the hook. Tighten the M10

x 90mm Bolt (77) and the M10 Nylon Locknut

(not shown).

13. Wrap the Long Cable (23) around a “V”-Pulley

(6). Attach the “V”-Pulley and a Long Cable Trap

(50) to the indicated bracket on the Front Upright

(42) with an M10 x 60mm Bolt (7) and an M10

Nylon Locknut (21). Be sure that the Long

Cable Trap is positioned to hold the Cable in

place.

14. Route the Long Cable (23) around the “V”-Pulley

(6) on the Left Arm (47). Be sure that the Cable

is in the groove of the Pulley and that the

Long Cable Trap (50) is positioned to hold the

Cable in place. Tighten the M10 x 60mm Bolt (7)

and the M10 Nylon Locknut (not shown).

Hook

Ball

Cable Assembly

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Weider WESY19511 User Manual Page 9