Weider WESY19511 User Manual download pdf (Page 10)

15. Route the Long Cable (23) around the “V”-Pulley

(6) on the Right Arm (48). Be sure that the

Cable is in the groove of the “V”-Pulley and

that the Long Cable Trap (50) is turned to hold

the Cable in place. Tighten the M10 x 60mm

Bolt (7) and the M10 Nylon Locknut (not shown).

16. Route the Long Cable (23) around the 90mm

Pulley (15) attached to the Pulley Bracket (20).

Be sure that the Cable is in the groove of the

Pulley and that the Cable Trap (66) is turned

to hold the Cable in place. Tighten the M10 x

45mm Bolt (80) and the M10 Nylon Locknut (not

shown).

Be sure that the M8 x 115mm Bolt (68) is properly

tightened and that the Pulley Bracket (20) can

move freely.

17. See the inset drawing. Attach a 90mm Pulley (15)

and a Cable Trap (66) to the indicated hole in the

Long “U”-Bracket (57) with an M10 x 50mm Bolt

(12) and an M10 Nylon Locknut (21). Be sure

that the Cable Trap is inside the “U”-Bracket.

Note: This may come pre-assembled.

Route the Long Cable (23) between the 90mm

Pulley (15) and the Cable Trap (66). Be sure that

the Cable is in the groove of the Pulley and

that the Cable and Pulley move smoothly.

18. Note: The 90mm Pulley (15) in this drawing is

pre-assembled. It is shown disassembled for

easy part identification.

Route the Long Cable (23) around the 90mm

Pulley (15) attached to the bracket on the Top

Frame (55). Tighten the M10 x 45mm Bolt (80)

and the M10 Nylon Locknut (21). Be sure that

the Cable is in the groove of the Pulley and

that the Cable and Pulley move smoothly.

Bracket

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

Weider WESY19511 User Manual Page 10