Weider 141 User Manual download pdf (Page 28)

56. Wrap the Low Cable (80) under a Small Pulley

(74). Attach the Small Pulley and two Half Pulley

uards (91) to the Weight Carriage Base (20)

with an M10 x 45mm Bolt (140) and an M10

ylon Locknut (153). M

ake sure that the Half

Pulley Guards are oriented as shown.

57. Attach the Low Cable (80) to the “U”-bracket

(158) with an M8 Nylon Locknut (170) and an M8

Washer (164) (see the inset drawing). Tighten

the Nylon Locknut exactly two full turns onto

the Cable.

158

170

140

153

164

158

170

164

58. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in

ADJUSTMENT

, beginning on the following page.

Before using the weight bench, pull each cable a few times to make sure that the cables move smoothly

over the pulleys. If one of the cables does not move smoothly

, find and correct the problem.

IMPORT

ANT: If

the cables are not properly installed, they may be damaged when heavy weight is used. See the

CABLE DIAGRAM on page 34 for proper cable routing. If there is any slack in the cables, you will

need to remove it by tightening the cables. See MAINTENANCE on page 33.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

No comments

Weider 141 User Manual Page 28