Weider Club C4800 User Manual download pdf (Page 19)

44. Note: The following steps are shown from the

back of the weight system.

Route the Leg Press Cable (65) under a 100mm

Pulley (38). Attach the Pulley and a Long Cable

Trap (68) to the Leg Press Base (3) with an M10

x 92mm Bolt (55), an M10 Washer (99), and an

M10 Nylon Locknut (101). Make sure the Cable

Trap is oriented to hold the Cable in the

groove of the Pulley.

46. Wap the Leg Press Cable (65) under a 90mm

Pulley (39). Attach the Pulley and a Short Cable

Trap (48) to the Base (1) with an M10 x 50mm

Bolt (81) and an M10 Nylon Locknut (101). Make

sure the Cable Trap is oriented to hold the

Cable in the groove of the Pulley.

45. Wap the Leg Press Cable (65) around a 90mm

Pulley (39). Attach the Pulley and a Short Cable

Trap (48) to the M10 x 121mm Carriage Bolt (49)

in the Base (1) with an M10 Nylon Locknut (101).

Make sure the Cable Trap is oriented to hold

the Cable in the groove of the Pulley.

47. Attach the end of the Leg Press Cable (65) to the

“U”-bracket (40) with an M8 Washer (100) and an

M8 Nylon Locknut (87). Note: Do not complete-

ly tighten the Locknut; it should be tightened

so that only two threads of the Cable show

past the Locknut, as shown in the inset draw-

ing.

Large

Ball

101

100

48. Identify the Ab Cable (66). Route the Cable

under a 100mm Pulley (38) and through the Leg

Lever (7) and the Leg Lever Base (5). Attach the

Pulley inside the Leg Lever with an M10 x 65mm

Bolt (80), two M10 Washers (99), two 12.5mm

Spacers (69), and an M10 Nylon Locknut (101).

Make sure the large ball on the Cable is in the

position shown.

101

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 40 41

No comments

Weider Club C4800 User Manual Page 19