Weider Club C4800 User Manual download pdf (Page 17)

35. Attach the end of the Butterfly Cable (67) to the

“U”-bracket (40) with an M8 Washer (100) and an

M8 Nylon Locknut (87). Note: Do not complete-

ly tighten the Locknut; it should be tightened

so that only two threads of the Cable show

past the Locknut, as shown in the inset draw-

ing.

36. Identify the Lower Short Stack Cable (64).

Attach the Cable to the Base (1) with an M8 x

67mm Shoulder Bolt (90), two M8 Washers (100),

and an M8 Nylon Locknut (87).

37. Wrap the Lower Short Stack Cable (64) over a

100mm Pulley (38). Attach the Pulley to the

Double “U”-bracket (42) with an M10 x 45mm Bolt

(51) and an M10 Nylon Locknut (101).

38. Note: The following steps are shown from the

back of the weight system.

Wrap the Lower Short Stack Cable (64) under a

100mm Pulley (38). Attach the Pulley and a Long

Cable Trap (68) to the Base (1) with an M10 x

45mm Bolt (51). Make sure the Cable Trap is

oriented to hold the Cable in the groove of the

Pulley.

34. Route the Butterfly Cable (67) through the

Butterfly Upright (2) and over a 100mm Pulley

(38). Attach the Pulley and a Long Cable Trap

(68) to the Butterfly Upright with an M10 x 50mm

Bolt (81) and an M10 Nylon Locknut (101). Make

sure the Cable Trap is oriented to hold the

Cable in the groove of the Pulley.

100

101

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 40 41

No comments

Weider Club C4800 User Manual Page 17