USER'S MANUALQUESTIONS?As a manufacturer, we are com-mitted to providing completecustomer satisfaction. If youhave questions, or if there aremiss
10CABLE ASSEMBLYAs you assemble the cables and pulleys insteps 14 through 22, please refer to theCABLE DIAGRAM on page 22 of this manual.14. Route the
14CABLE ASSEMBLY22. Attach the Long Cable (23) to the Small “U”-Bracket (67) with a 1/4” Nylon Locknut (2)and a 1/4” Washer (10). Do not completelytig
CABLE ASSEMBLY12369581521669291720212210586710575820. Route the Short Cable (58) around the 3 1/2”Pulley (15) attached to the upper hole in thePress F
IMPORTANT: Assembly is divided into four stages: 1) frame assembly, 2)arm assembly, 3) cable assembly, and 4) seat assembly. The hardwarefor each stag
5/16" Nylon Locknut (3)1/4" Washer (10)5/16" Washer (8)1" Retainer (69)1/4" x 2 1/2" Screw (43)5/16" x 1 3/4"
81Note: “#” indicates a non-illustrated part. Specifications are subject to change without notice. See the back coverfor information about ordering re
231111885527121544157123214421361603355114192651256463376729923341276541104332165074275062169706970474844454445525339496221067543131741268553216615207
2TABLE OF CONTENTSIMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The decals shown below have been placed on the weight system in the locations shown. If decals aremissing or illegible, please call our Customer Servi
4BEFORE YOU BEGINASSEMBLED DIMENSIONS: Height: 188 cm (74 in.)Width: 102 cm (40 in.) Length: 135 cm (53 in.) Foot PlateLow Pulley StationHigh Pulley S
5ASSEMBLY156High Side ofBracketHandles3551Long Side31511411274Before beginning assembly, carefully read thefollowing information and instructions:• Pl
6FRAME ASSEMBLY2. Slide the Front Upright (42) onto the 5/16” x2 1/2” Carriage Bolts (1) in the Base (4).Hand tighten a 5/16” Nylon Locknut (3) ontoea
5. Lubricate the pedal axles on the Rear Upright(56). Slide the Left Pedal (79) onto the leftpedal axle, and the Right Pedal (78) onto theright pedal
8FRAME ASSEMBLYARM ASSEMBLY9. Press the Weight Tube Bumper (64) into theend of the Weight Tube (63). Insert theWeight Tube into the stack of Weights (
9ARM ASSEMBLY12. Wet the handle of one Press Arm (46) withsoapy water. Slide a 5” Plastic Grip (31) ontothe handle. Press a 1” Round Inner Cap (49)int
Comments to this Manuals