10
9
26
26
12
12
9
Indents
19
3
3
19
9. Attach the Pull-up Bar (9) to the Pull-up Frames
(3) with two M10 x 50mm Screws (19) and two
M10 Curved Washers (26). Make sure that the
indented holes in the Pull-up Bar are on the
side shown. Then, press the two Rubber Caps
(12) into the ends of the Pull-up Frames.
See steps 3–8. Tighten all of the M8
Locknuts (22).
10. Orient the Backrest (8) as shown. Attach the
Backrest to the Top Crossbar (7) with four M6 x
16mm Screws (27) and four M6 Washers (21).
10
8
27
21
21
7
27
Comments to this Manuals